My Xecuter Case Sucks!!!

I have heard nothing but positive feedback from all the reviews but my experience hasn't been so pleasant. I just got a red transparent red Xecuter replacment case and installed it. Everything fit together perfectly , I though it was going to be really cool. Then I tighten all the screws and put in a full size disc to try it out. Well the disc scraps against the inside lip of the lid and stops spinning. If I power on the GC with the lid closed the discc won't spin at all. I have taken the case off and looked over eveything a number of times to made sure everything is seated correctly and all the screws are fastened.

After tinkering around I discovered that if I pressed firmly on the back side of the lid, just above the handle on the back of the cube, the disc would spin fine as long as I was pressing on the lid. So I took the cover off again, loosed the three screws that hold the lid on place, pressed on the lid and tightened the screws back in again. After that it seems that the disc spin fine. I hope that this helps anyone esle that runs into this.

morale of this story:
if something doesnt fit, tighten the screws

It did fit, it wasn't a matter of just tightening. The lid had to be moved fwd a few mm