My New Clear Case

I just got my clear case today and it looks great. I also did a small mod to the back of my case to add a usb port.... I had to use a file to make the hole so its kinda rough on the edges of the hole but it looks ok. If you look in your gamecube there is a little slot on the inside that almost looks like it was made for the Qoob USB chip cuz it fits perfect like a little shelf for it. Anyway here are the pics!

http://members.aol.com/nitroxeno/1.jpg
http://members.aol.com/nitroxeno/2.jpg
http://members.aol.com/nitroxeno/3.jpg
http://members.aol.com/nitroxeno/4.jpg
Ebay Auction If you would like to purchase

Looks pretty good! Change your power LED to a green or blue one though.

Yeah thats my next mod... i was thinking blue but then it won't match the qoobs light so mabey green is a good idea.... then it will match my xbox too.

how easy is it to make the lights a differnet colour, i was thinking of getting a clear case for my black cube (i also have a purple one!) and yours looks really cool. but the lights being blue would look very cool!!!!

neosalad

Just out of Curiosity, why didn't you get a black one so that it would match your bottom, I'm not quite sure if the two really mesh too well.

Originally posted by neosalad
how easy is it to make the lights a differnet colour, i was thinking of getting a clear case for my black cube (i also have a purple one!) and yours looks really cool. but the lights being blue would look very cool!!!!

neosalad

What I do is just snip the old LED off, then cut the new leds legs so that they are the same length as the led that you just snipped off. Then just make sure you have the - and + legs the right way and then solder it to the little snubs of the previous leds legs on the controller board.

that doesnt look too bad i suppose (the black bottom / clear top)

out of interest is this a gamecubecase one or different? and did you have any difficulties installing it.

i`m gonna be getting a few of these next week, and thinking of selling them premodded (just the cases with LED`s fitted).

but yeah go for clue, everyone loves blue

It's a gamecubecases one

I got a clear case today also. It fits better than my other black replacement case. The lid pops up to fast though. I tried to put one screw in before I put the case on. It seemed too hard to get in like my black case. So for now, I am not putting the screws in. I drilled the holes in my black case, so I could get the screws in.
Now where can I get a replacement LED online? I saw some modchip seller that had some. But I can't find that site again.

Originally posted by Dixon Butz
Now where can I get a replacement LED online? I saw some modchip seller that had some. But I can't find that site again.

I have about 30 blue leds, if you wanted I could sell you a couple for $0.17 each(what I got them for) + $0.50 for shipping.

Originally posted by Quantumsource
Just out of Curiosity, why didn't you get a black one so that it would match your bottom, I'm not quite sure if the two really mesh too well.

I went with clear because the other ones don't have any power lights and i thought it would look cool. Black would be trying to make it look stock when its far from being stock. If I'm going to buy a new case might as well make it differnt. Besides clear goes with anything.... its clear.

Here is some pics of my clear case

Originally posted by Dixon Butz
Here is some pics of my clear case

Whats up with your wireless controller reciever

That is for a Nyko Air Flow wireless

Originally posted by Xboxmodder999
Whats up with your wireless controller reciever

Here is a better shot.