Internal Wavebird Receiver [Archive]

dsltech_dude

07-25-2005, 11:30 AM

I read a tut somewhere about putting the wavebird's receiver inside the GC. Now, I can't find it. Anyone remember where this was or who wrote it? I've searched these forums along with some other ones... and can't find it. :confused:

Thanks in advance,

DSLTech_Dude

dsltech_dude

07-26-2005, 09:09 PM

NVM,

Found it. :rolleyes:

Mods please close.

motombo

08-01-2005, 12:41 PM

Hello... so you found it?

Could you tell me where to get it? I have never heard something like that existed.

Thanks ;)

dsltech_dude

08-01-2005, 12:48 PM

Couldn't find it when I searched for it, until I did find it. Now it's available in the forum search. Anyway, here's the TUT:

http://forums.maxconsole.net/showthread.php?t=6648&highlight=wavebird

DSLTech_dude

Jooses

08-27-2005, 02:41 PM

Oh i had a great idea! I'm not sue how difficult it is to keep the LEDconnected to the reciever, but I would like to know if i can extend the leads on the LED with some wire and place the reciever behind the fan and keep the LED over the contorller ports where the ". .. ... .... " dots are. so when the reciver gets the signal the hole over the port lights up. I'm going to try it ASAP.

wing_nut

08-31-2005, 07:31 PM

Oh i had a great idea! I'm not sue how difficult it is to keep the LEDconnected to the reciever, but I would like to know if i can extend the leads on the LED with some wire and place the reciever behind the fan and keep the LED over the contorller ports where the ". .. ... .... " dots are. so when the reciver gets the signal the hole over the port lights up. I'm going to try it ASAP.
i did this on mine. you have to desolder the SMD LED first then just add your LED (no need for a resistor). just be careful not to pull a pad.