marrad
04-09-2005, 01:52 PM
Hi
I have one of the Panasonic Q (JAP/USA & Multi DVD region modified) (Panasonic)
Japanese NTSC
this the link http://www.lik-sang.com/info.php?category=77&products_id=1575&
The unit is multi region modifified.Jap en us original game plays it with no problem.No pal games
It plays also alle dvd movies from alle regions.
I have mod the cube with the viper.The motherbord is a normal rev.A.
I have install all wires,But there is no Lid sensor.So i do not know where toconnect theme
Purple Wire: This wire appears to be the harness wire that goes to the GC mainboard telling it the "bypass" state of the lid sensor... it gets it's information from the BLUE wires and bypass plugs hooked up during a Viper GC module installation. If this wire is disconnected, the console will boot to the GC menu, and if you select Play Game it will show a "?" on the screen even if an original GC disc is seated on the drive spindle. However, if you reboot the unit holding down the lid sensor (to replicate what this wire does) then the GC will boot directly into the game disc on the drive spindle as normal.
So that is the problem.
The viper starts but it hangs on the start screen no disk open and nothing working.Whene i turn of the viper de cube works normal.
Who knows where connect the Purple wire????
I have one of the Panasonic Q (JAP/USA & Multi DVD region modified) (Panasonic)
Japanese NTSC
this the link http://www.lik-sang.com/info.php?category=77&products_id=1575&
The unit is multi region modifified.Jap en us original game plays it with no problem.No pal games
It plays also alle dvd movies from alle regions.
I have mod the cube with the viper.The motherbord is a normal rev.A.
I have install all wires,But there is no Lid sensor.So i do not know where toconnect theme
Purple Wire: This wire appears to be the harness wire that goes to the GC mainboard telling it the "bypass" state of the lid sensor... it gets it's information from the BLUE wires and bypass plugs hooked up during a Viper GC module installation. If this wire is disconnected, the console will boot to the GC menu, and if you select Play Game it will show a "?" on the screen even if an original GC disc is seated on the drive spindle. However, if you reboot the unit holding down the lid sensor (to replicate what this wire does) then the GC will boot directly into the game disc on the drive spindle as normal.
So that is the problem.
The viper starts but it hangs on the start screen no disk open and nothing working.Whene i turn of the viper de cube works normal.
Who knows where connect the Purple wire????