Qoob pro BSOD most likely this is the problem

[unknown101]

I have repaired five GC form friends that had BSOD after instilling a Qoob pro but I fixed them all

The most common one
Not insulating wires/pin most people don’t insulate the solder point after soldering the wires on specially the heat-sink wire.

Most people overlook this one and this is the one that in most cases causes the problem.

The small PCB that connects to the Qoob (where the swatch connects) shorts on the aluminium drive casing of the GC you need some double tape to fix this.

These are picture to show what I mean

Hope this helps people

[Birdo]

I'll try those. I've been having some rather aggravating BSOD problems from the beginning.

[Birdo]

Oh crap, it still has the same problem.

[techno_hick]

check the 2 points that have to be bridged - I've fixed gc that where done sloppy and connected 3 spots. use a peice of wire rather then just solder