D1A wasabi v3 eject can't insert disc

[wTFl0l]

After ejecting the disc and when I attempt to remove the disc it automatically tries to pull the disc back in with nothing. Thus the drive won't take any disc when I try to insert another disc until I either click eject again or turn off the wii and turn it back on. I was reading through a couple of other threads however couldn't figure out what was wrong. Btw I have a Wasabi version 3. I also didin't know whether or not to use the 1.2 beta update. Thanks for any comments.

[PSPWAD]

You may want to see if the chip's site has a forum and see if there is anyone else with this issue. The update MIGHT fix it if it is a known issue (or even if it's not), but I would check with them first.

[wTFl0l]

You may want to see if the chip's site has a forum and see if there is anyone else with this issue. The update MIGHT fix it if it is a known issue (or even if it's not), but I would check with them first.
Thanks for your comment however I already have looked on their website http://www.wasabi.net.cn/ and I couldn't find any information about this issue.

[PSPWAD]

Personally I'd try the firmware update, but if you are not sure about it contact them directly and get input from them.

[Azariel]

After ejecting the disc and when I attempt to remove the disc it automatically tries to pull the disc back in with nothing. Thus the drive won't take any disc when I try to insert another disc until I either click eject again or turn off the wii and turn it back on. I was reading through a couple of other threads however couldn't figure out what was wrong. Btw I have a Wasabi version 3. I also didin't know whether or not to use the 1.2 beta update. Thanks for any comments.

Did you try the longer Clk wire?