Wiizard install, drive does nothing

[djkouza]

I just installed a wiizard on my D2C (D2C2) whichever I'm not sure, but I've double checked everything and when I power on the Wii the drive does NOTHING(no spin up nothing and yes it's plugged in), ok so I removed chip and then the drive works fine. I figured ok maybe I'll try the Alt X, tried that and now the drive is once again unresponsive. Is this a symptom of a dud chip, a certain wire installed bad? I've tried jumpers for D2C and D2C2 and same result.:confused:

[tech3475]

try using a multimeter to test the connections and the chip.

[djkouza]

try using a multimeter to test the connections and the chip.

Tested connections with meter didn't find any bridges and everything seemed to tone out to the right pin/pad
I've done Wiikeys/ PS2 Magic 2/3, 360 chips wouldn't call myself an expert, but would say I'm proficient with solder. I'm just stumped here.

[djkouza]

LED2 is Green LED1 is Red if that helps anyone to tell what is happening.

[didineedthis]

I just installed a wiizard on my D2C (D2C2) whichever I'm not sure, but I've double checked everything and when I power on the Wii the drive does NOTHING(no spin up nothing and yes it's plugged in), ok so I removed chip and then the drive works fine. I figured ok maybe I'll try the Alt X, tried that and now the drive is once again unresponsive. Is this a symptom of a dud chip, a certain wire installed bad? I've tried jumpers for D2C and D2C2 and same result.:confused:

have you tried this (http://www.wiizardmod.com/advanced.jpg)

didineedthis

[lenselijer]

buy a proper chip, i use d2pro and it worked on every wii and ive done loads of them.

[somegamer]

Well, post a pic of your install and we could all take a look at it.

[djkouza]

Found out my CK trace was damaged, and jumpered around that and now it works great. Many thanks to everyone here and especially to the Support team for Wiizard, I definitely will say that the Wiizard is a proper chip and it works great now that I'm past my mistake!!