d2pro with wii-clip

[pikai118]

The new WII-CLIP install diagram: Plug and Play, 0 wires
(If need use region free option, then need solder 5 / 6 / 7 / 8 four wires). My question is, if you I need to use the region free option I will solder 5,6,7,8 isnt it? but what about the jp1 and jp2 points those points are also an option for specific region free?thanks

To enable region free compatibility, close the jumper(s) to match the region of your console.
JP1 JP2
No region override 0 0
Patch for PAL 0 1
Patch for USA NTSC 1 0
Patch for JAPAN NTSC 1 1



what does it mean close the jumpers? how?thanks

[didineedthis]

The new WII-CLIP install diagram: Plug and Play, 0 wires
(If need use region free option, then need solder 5 / 6 / 7 / 8 four wires). My question is, if you I need to use the region free option I will solder 5,6,7,8 isnt it? but what about the jp1 and jp2 points those points are also an option for specific region free?thanks

To enable region free compatibility, close the jumper(s) to match the region of your console.
JP1 JP2
No region override 0 0
Patch for PAL 0 1
Patch for USA NTSC 1 0
Patch for JAPAN NTSC 1 1



what does it mean close the jumpers? how?thanks

JUST BRIDGE THE JUMPER WITH SOME SOLDER TO MATCH YOUR REGION EG
jumper 1 has 2 pads "solder the 2 pads together" this closes the jumper.

didineedthis

[pikai118]

hi, can post a diagram where to solder? my unit is pal and i want to patch usntsc. And I will still solder 5,6,7,8, even I already bridge the jumper? thank you.

[didineedthis]

hi, can post a diagram where to solder? my unit is pal and i want to patch usntsc. And I will still solder 5,6,7,8, even I already bridge the jumper? thank you.

you can get a diagram from here http://www.d2pro.com/resources.html


didineedthis